The ETC has a built-in failsafe mode to prevent this from happening. But if the controls arent working, then youll be unable to accelerate the way you should when you press the pedal. So, with the light alone we cannot precisely find out the component that has failed. Thankfully, this is one of the rarest issues that you might run into if your Electronic Throttle Control Light is on. If the problem persists, check fuse #10 and #20 front box. So i shutoff car and started it back up. At that point the dash lites lite up,and everything se 2001 Chrysler Town & Country Limited LWB FWD. ETC & MIL - electronic throttle control & malfunction indicator light - lights are on. When I turn the key, it grinds just fine, but won't start AND doesn't automatically turn off when I let go of the key. Your cars whole throttle body or unit can accept inputs from multiple sources thanks to an ETC. I have a 2005 Chrysler 300 Hemi and the red lighting bolt is on. SOURCE: The electronic throttle control light is flashing in my 2004 1500 5.7 Hemi truck, won't accelerate but does turn on, where should i start? When you first notice the light, it will likely still work to some degree. So, how can you be certain? Sometimes the RPM during idle might be just fine, but you might see it suddenly surge or stagger. All of my lights, windows and radio are working though. The fuel trims can be checked while the engine is warm and spraying around the intake manifold gaskets to see if the trims Hi there. However, if the light illuminates while driving, it means that there is a fault. A slightly reduced acceleration today might turn into a full-blown failure to accelerate when you need to tomorrow. Last updated on January 13th, 2023 at 08:30 pm. So, you might see that the check engine light is flashing. could that be true? No oil light came on, there was plenty of that in there. You should pull over whenever you press the accelerator pedal, and the car doesnt accelerate. Start by replacing the wires. Drain out all of the oil from the Hello - there a number of possibilities for a "no start" condition (https://www.yourmechanic.com/question/the-car-crank-but-won-t-start-by-emad): dead or weak battery, ignition switch, starter solenoid or motor. Yes it could happen if the battery was removed or if you have low voltage on the battery, see if you have 12 volts. Electronic throttle controls are an improvement, but they are not without flaws. depressed the accelerator pedal Despite not being the most attractive part of your car, it is one of the most crucial. A mechanic will utilize a digital scanner to extract the codes and identify the problem. Without it, your car will malfunction. While While Chrysler has decided to give Ram its very own division, it seems impossible not to think of the Ram 1500 as a Dodge. Consider that modern cruise control systems would not be possible without the ETC. Come join the discussion about SRTs, performance, modifications, classifieds, troubleshooting, maintenance, engine swaps, and more! 2012 T&C battery was fine, fuel half full, but suddenly wouldn't turn over or start and the Electronic Throttle Control (ETC) light came on. Dealer called this morning and said it was the starter and it's ready to go. The acceleration pedal position sensor sends the current position of the accelerator pedal to the control module. Slowly depress the accelerator pedal all the way to the floor. 2010 GMC Acadia. This electric unit paved the path for the development of cruise control and adaptive cruise. VerticalScope Inc., 111 Peter Street, Suite 600, Toronto, Ontario, M5V 2H1, Canada. I have a dodge caliber 2007 and I had to replace my starter. And then, the engine seems to have very poor idling. To put a number on it, it will last more than a decade. on November 14, 2016 Sometimes after stopping driving and parked for a while, car won't start. This will keep your engine running, but youll often end up using way too much fuel since the ECU cant optimize it for your current driving conditions. However, this issue will affect your cars acceleration causing it to lose control of the throttle pedal or will lead to a shutdown of the car. If your battery is 3 or more years old it may be going bad. Starter. Everything functions independently and warns the driver of any issues, whether a low tire, a faulty oxygen sensor, or your throttle control. Electronic Throttle Control light on. An electrical system uses multiple wires in order to transport its signals. My car has 122000 miles. The failure of the electronic throttle control may be apparent if, despite depressing the accelerator pedal, you cannot accelerate beyond a slow crawl. When the ETC fails, it might control the throttle without your input. Asked by Humphrey Aug 22, 2018 at 11:07 AM about the 2015 Dodge Journey. W have a 2016 T&C. How to Reset the Chrysler Pacifica Navigation (Uconnect), What might you experience when it illuminates. To answer your location question, the ECM is behind the fuse and relay block of electronics under the passenger side of the dash (behind the glove box). The repair procedure is not hard, nor does it take a lot of time. You can clean it with a good throttle body cleaner to see if that solves the problem. JavaScript is disabled. The issue will impact how quickly the automobile accelerates and could result in a complete loss of control over the throttle or the vehicle shutting down. It really depends on what is actually damaged which would determine the ballpark estimate for repairs. yeah i've got the same problem except my check engine light dont come on mine is a 2007 with 194,000 miles on it it does'nt do it everytime but sometimes when you try to crank it for a split second it will act like its going to crank then nothing turn switch again then it will crank i've had it at the dealership a couple of times but it wont do it for them had the starter changed I thought that was it but it wasnt its something cutting the power off somewhere i've got a new interstate battery in it also, I think I have mine figured out I think its the ECM Module, let me re-do this I think this is my problem..03/04/08 0708 . button and it started normally If any of the lights are flashing, its alright as long as they turn off after a few seconds. in accessory mode, SLOWLY Turn off all your electric accessories such as the radio, AC, and heater. This might be caused by a variety of reasons. Having problem in accelerating 3. No lights no radio nothing except the This sensor tells the ECU the throttle bodys current position, so the ECU knows the perfect fuel and timing ratios to adjust everything else too. ESP/TCS Indicator Light 2. With the ETC, you do not need regular maintenance. Anyone with similar experiences? Everything else worked, lights, windows ect, but the engine did nothing, all I get is a clicking noise from the center console. the associated trouble code should identify a problem with the throttle controller, which can then be repaired. The Fora platform includes forum software by XenForo. ), then reinstalled them, and then disconnected both battery cables and held them together for 2 minutes so that the engine controller could reboot with the factory default . Dont worry; well break down everything you need to know about electronic throttle control warning light flashing to get that light turned off and get you back on the road in no time! Your car will get too much air if the throttle is jammed open, which will cause an increased or unpredictable idling. Carfax shows minor damage no airbag deployed. Join our community to discuss the Jeep Patriot & Jeep Compass. Now turn the engine on and leave it on idle. This would depend on the severity of the oil leak (https://www.yourmechanic.com/services/oil-fluid-leak-inspection). The throttle body should open with minimum effort and should close automatically as soon as you release it. Additionally, loose wires or connectors could mimic this type of issue. Read this also How to Fix the Electronic Throttle Control 5.7l Hemi. Thanks for the question tonight. -I have a 2007 300c base with 102,000 miles on it. Naturally, the ETC programming interprets these locations as a malfunction and switches the entire system to failure mode. Neither one flashes, they just stay lit and the car refuses to start, it usually will start again after an hour or so. But while electronic throttle controls are a step in the right direction, they arent perfect. multiple lights showing up on my dashboard: 1. This happens if the filter is unable to do its job. I worked on a 2008 town country and the With a mechanical unit, failures are more common. The ETC is a part of that. First off, you need to look at the maintenance aspect. is my last car to buy from this dealership. ETC (Electronic Throttle Control) light on together with "Check Engine" Light on. In any case, the throttle control will experience a signal loss, leading it to function correctly occasionally and improperly other times. Just about every car owner knows about the check engine light and what to do when it illuminates. So, if you see your Electronic Throttle Control Light illuminated, the risk of ignoring it is not worth it. Turn the ignition key to "OFF" position. At this point, your vehicle is running a system check, and everything is perfectly normal. The ETC is a unit that doesnt fail regularly. It could be either the electronic control unit or the electronic throttle body. the engine did nothing, all I get is a clicking noise from the. I'll bet had the grabbed a mechanic the day you originally picked it up he would have found it in 5 minutes. Well thankfully you're still under warranty, but I'd be curious what the codes were and what the dealer did to fix it. Usually, electrical units do not need a lot of maintenance compared to mechanical units. ESP/BAS Indicator Light. It doesn't make any noise. I manually turn the key back to off to stop. Malfunction Indicator Light 3. free. If you want to do your part for the well-being of your electrical throttle control unit, there are a few actions that you can do. When you purchase through links on our site, we may earn an affiliate commission, which supports our community. If it were that easy, thieves would figure that out quickly and more cars would be stolen. And what would have broken off and fallen under my car? This is one of the worst things to encounter. Understanding the Chrysler Oil Change Indicator and Service Indicator Lights. The 1st thing that MUST be done is to have the electronic engine control system computer (called the "PCM") scanned for fault codes, this gives you the starting point for diagnosis od why the warning/fault light is on. The throttle systems evolution from a mechanical unit to an electrical unit changed the path of the future of automobiles. Before you proceed, make sure that your check engine light is not on. YourMechanic All rights reserved. new pcm, soldered a new pigtail connector Whether youre trying to slowly inch forward and end up accelerating wildly, or you need to punch it to get on the freeway, and you cant get the umph you need a faulty electronic throttle control can create severe consequences. I'll ask if it threw codes and stuff when I get there. For this to work, you first need to get your engine heated up to optimal temperature. Chrysler product isn't an option. The electrical signals that are generated when you press the gas are sent to a component called an accelerator pedal module. So, how to reset the Electronic Throttle Control Light. Nowadays, the majority of cars are entirely electronic. The process cannot be done if your check engine light is on. For older vehicles, note that there is no coupling between the throttle and the throttle in the current models of cars. Would that also cause my car not to start? Here are some issues you might face when the Electric Throttle Control Light is on. The check engine light indicates that something is wrong with your engine. Conversely, the throttle might close too much, either while idling or while driving. the engine did nothing, all I get is a clicking noise from the Also, note that this will trigger the Check Engine Light to illuminate on the dashboard.